MCG Cantilever Gate

The MCG sliding gate is designed for commercial, industrial and security applications. The modern design of the MCG eliminates the need for ground tracks and overhead rails. The cantilever system and customised options allow for a variety of motors and controllers to be installed dependent on the duty cycle of the gate.

	Construction Fully welded Australian made RHS steel is used in the gate frame, back runner and support posts, with 25 x 25mm RHS uprights. All fabricated steel is hot dipped galvanized for total protection and maximum life span. The MCG Sliding gate allows for single leaf spans of up to 10 metres. Powder coating is optional from a wide selection of powder coating colours. All rollers are supplied with sealed ball bearings which are designed to exceed gate loads and are capable of 100% duty cycle.and are capable of 100% duty cycle.
	Drive System Subject to change without prior written notice.] The construction of the MCG gate system allows for a variety of motors and controllers to be used dependant on the required duty cycle of the gate. A typical motor drive supplied by Magnetic Automation is the MSL20. A robust 3 Phase AC motor with a worm gear drive provides the linear movement of the slide gate through a gear wheel and a straight rack mounted to the gate. The drive system is designed for gates up to 600kg and speeds of up to 500mm/sec. Please contact your local Magnetic Automation office for further details.
	Safety Devices Standard safety devices include PE beams, inductive loop detectors and signage for use on automatic gate systems. Optional safety devices include flashing lights, audible alarms, safety edge strips, safety light curtains and polycarbonate clear safety screens.
	Accessories A variety of accessories are available such as climb protection - spikes, barbed wire and pressed spears, uninterrupted power supply, steel cladding and chain wire mesh. Bi-parting gates can also be applied to wide roadways.